AltSpace Wiki

The laser is running an esp32 based control board running FluidNC. It is configured via a config file which you can access over the usb serial interface and the web installer. FluidNC is made to be compatible with GRBL flavored gcode but does not allow configuration for many things over gcode like the original grbl firmware.

http://wiki.fluidnc.com/en/home https://installer.fluidnc.com/

• backup configs
• get static ip
• implement physical controls
• replace worn x axis belt
• implement automatic focusing
• replace rubber rollers
• make informed settings recommendations

the laser source needs a “tickle” to warm up before it will fire. this is done in lightburn with some custom gcode that runs at the start of a job