Differences

This shows you the differences between two versions of the page.

--- laserworks:technical_details [2026/04/10 22:33] – created altspace
+++ laserworks:technical_details [2026/04/13 23:00] (current) – [quirks] altspace
@@ Line 1: / Line 1: @@
-===== TODO =====
+===== Technical Details =====
+==== General Information ====
+The laser is running an esp32 based control board running FluidNC. It is configured via a config file which you can access over the usb serial interface and the web installer. FluidNC is made to be compatible with GRBL flavored gcode but does not allow configuration for many things over gcode like the original grbl firmware.
+http://wiki.fluidnc.com/en/home
+https://installer.fluidnc.com/
+==== TODO ====
   * backup configs
   * get static ip
@@ Line 9: / Line 19: @@
   * make informed settings recommendations
-===== quirks =====
+==== quirks ====
 the laser source needs a "tickle" to warm up before it will fire. this is done in lightburn with some custom gcode that runs at the start of a job
+The stepper drivers, for whatever reason, don't like having multiple homing cycles.